Speakman SENTINEL MARK II ROYALE SHOWERPAC S-1590 Installation, Maintenance & Operation Instructions

Installation, Maintenance & Operation Instructions

DESCRIPTION

Speakman Sentinel Mark II® Royale™ SHOWERPAC® exposed anti-scald balanced pressure SHOWERPAC®.
• 18 gauge stainless steel outer shielding.
• Stainless steel self-draining soap dish.
• Chrome plated brass lever handle.
• Adjustable temperature limit stop.
• Brass valve body.
• Integral spring check stops.
• ROYALE™ Pressure balancing module.
• Concealed integral mounting lugs.
S-2292 showerhead with flow control device reduces flow to 2.5 GPM/9.46 L/min maximum to meet existing
ANSI A112.18.1M Standard. Standard ½" copper tube inlets through the wall or dropped from the ceiling.
Vandal resistant construction. Meets ASSE 1016.

SpecificAtions

SUPPLY: ½" COPPER TUBE INLETS
FLOW RATE: SHOWERHEAD, 2.5 GPM/9.46 L/min MAX
Options:
LH
Less Showerhead
Stainless steel vertical pipe
VPC-2
cover, 2 ft. (610mm) sections.
(Must order as separate item.)

INSTALLATION

Note: Refer to the complete installation/rough-in literature supplied with the valve.
1. Remove the complete unit from the box. Remove the shield assembly from the valve unit
by removing the screw above the showerhead elbow and the screw near the dial cap.
Save the two (2) screws.
2. Determine the horizontal positioning of the valve unit. Determine the floor to showerhead heights
from the Recommended Head Heights chart.
3. Holding the unit against the finished wall in the proper position, mark the location of the top mounting
bracket holes (2), and the bottom mounting bracket hole (1). Remove unit from the wall and install
any mounting anchors (not provided), as detailed by the individual room specifications.
4. Position the unit against the wall, secure top mounting bracket screws (2) (not provided). Secure
bottom mounting bracket screw (1) (not provided). Be sure to select hardware appropriate for
the material you are mounting to. (I.E. wood screws, anchors, etc.)
5. Connect the supply lines to the inlets of the units. Supply lines must be on 4-13/16" centers. If unit
has top supply lines they must also be 17/32" from center of lines to finished wall. Do not secure top
supply lines to wall until complete Showerpac® unit with shielding has been installed. Place handle on
valve spindle and rotate counter-clockwise. Remove handle, turn both supplies on and check supply
line connections for leaks.
6. Attach bottom/soap dish plate to shield with three (3) 3/8" long screws provided. Make sure back
edge of plate is flush with side edges of shield. Tighten screws with 1/8" Allen wrench (provided).
Attach top cover plate to shield same as above on unit without a vertical pipe cover (VPC-2).
Unit with a VPC-2 does not use the top cover plate.
400 Anchor Mill Rd. New Castle, DE 19720
SPEAKMAN
S-1590
SENTINEL MARK II® ROYALE™ SHOWERPAC®
SPEAKMAN
09/01/15 www.speakman.com
®
2 – S-2252 ANYSTREAM® Shower head
3 – S-2253
ANYSTREAM® Shower head
®
Phone: 800-537-2107
92-S-1590-R2
Fax: 800-977-2747