Table of Contents
Advertisement
Figure 10: EVK-M101/C UART baud rate configuration
Setting a different baud rate will interrupt communication. If other configuration keys
were set after, these will not be applied. Therefore, the new baud rate needs to be selected
manually to resume communication and apply the remaining configuration items.
8.2 GNSS configuration
The default GNSS constellations that are enabled on the receiver are GPS, Galileo, SBAS and
QZSS. The receiver GNSS configuration can be updated by selecting the constellations in the GNSS
Configuration View as shown in
Figure 11: EVK-M101/C receiver GNSS configuration
8.3 Navigation update rate
The CFG-RATE-MEAS configuration key that is shown in
the navigation update rate. The navigation update rate value is defined in ms, where 100 ms
corresponds to 10 Hz. The default update rate is 1000 ms which corresponds to 1 Hz. The default
1 Hz update rate is a good tradeoff between position accuracy and power consumption. Certain
applications require faster update rates for high performance but this will increase the receiver
power consumption.
UBX-21003949 - R04
C1-Public
Figure
11.
8 Device configuration
EVK-M101, EVK-M101C - User guide
Figure 12
can be used to configure
Page 20 of 30
Advertisement
Table of Contents
