Record Mode; Manual Recording; Timing Recording; Motion Based Recording - Speco N8NRE User Manual

Record & Disk Management

7.3 Record Mode

7.3.1 Manual Recording

Method One: Click on the tool bar at the top of the live view interface to enable recording of the camera.
Method Two: Go to the live view interface and then click the right-click menu "Manually Record On" in the camera window or click
bar under the camera window to start recording.
Note: Click Start
interface. Click "Apply" to save your settings.

7.3.2 Timing Recording

Timing Recording: the system will record automatically according to the schedule.
Set the timing record schedule of each camera. See 7.1.2 Schedule Settings for details.

7.3.3 Motion Based Recording

Motion Based Recording: the system will start motion-based recording when the motion object appears in the setup schedule. The setup steps are
as follows:
① Set the motion-based recording schedule of each camera. See 7.1.2 Schedule Settings for details.
② Enable the motion and set the motion area of each camera. See 11.2 Motion Alarm for details.
The camera will start motion-based recording once you finish the above steps.

7.3.4 Sensor Based Recording

① Set the sensor-based recording schedule of each camera. See 7.1.2 Schedule Settings for details.
② Set the NO/NC type of the sensor, enable the sensor alarm and then check and configure the "Record". See 11.1 Sensor Alarm for details.

7.3.5 AI Event Recording

① Set the analytics recording schedule of each IP camera. See 7.1.2 Schedule Settings for details.
② Enable the intelligent alarm detection (object detection, exception, tripwire or intrusion) and draw alert surface or warning area of each IP
camera. See 9 AI Event Management for details.
The camera will start analytic recording once you finish the above steps. This function is only available for some Speco Blue IPCs.

7.4 Disk

7.4.1 Disk Management

➢
Disk Management
Click Start→Settings→Disk→Disk Management to go to the disk management interface. You can view the NVR's disk number and disk status and so
on in the interface. Click "Format" button to format the HDD.
Data Encryption:
① Click "Data Encrypt".
② Enter the username and password used to log into the NVR. This username and password must have disk management permission.
③ Check the disk you want to encrypt and then enter the password.
After you encrypt the data of a disk, this disk cannot be read by other NVRs unless it is unlocked.
Data Decryption:
① Click "Change Encryption".
② Enter the username and password used to log in the NVR. This user must have disk management permission.
③ Check the disk you want to decrypt and then clear the password.
→ → →
Settings Record Mode Settings and then set the manual record time in the
38
NVR User Manual
on the tool