Table of Contents
Advertisement
Select the channel of connected camera
6.1.1.3 Record Setting
In the Recording setup window, click OK to accept the new settings, click Exit to exit without saving,
and click on Default to revert to the factory default values.
(1)
(2)
(3)
(1) Camera Icons
Select the camera number you want to set the recording setting. To select all the cameras, enable the
ALL check box. To select more than one camera, Right click on the camera icon. To select one camera
only, Left click on the camera icon. The camera icon turns purple when it is selected.
(2) Recording Mode
The horizontal blocks from 00 to 23 represent the time in 24-hour clock and the vertical block 1 to 7
represent the day in the week block (Sunday to Saturday). To record in full 24 hours and 7 days a week,
select the recording mode and click the
click Schedule button and select the Recording Mode , and then click on the time or day blocks. When
the system starts recording a red triangle mark would appear at the upper left corner of the screen.
The recording modes are listed below:
- Always Recording
Record the video from the selected camera and save it to the designated storage path
- Motion Recording
Start recording the video from the selected camera only when the system detects movement. Once
motion is detected, the system automatically saves the previous frames and stop based on the
button. If you want to only record at a particular time or day,
67
Advertisement
Table of Contents
