JPT YDFLP-E-20-M7-S-R User Manual page 21

YDFLP-E-20/30-M7 User Manual
Figure 17 Setting parameters and emitting
After selecting full control mode, user can set power, frequency, pulse width and then press
"edit" button to confirm. User can switch on/off emission when clicking "Laser" button.
Note: All the parameters except power can't be modified during emission.
Control MO signal
3
Figure 18 GUI control MO state
Ctrl MO: The "MO" button will be appeared on the interface after selecting Ctrl MO. User can
control the switching of MO signal while clicking this button. This setting will not be preserved
after power off.
4.1.2.2 Default parameter setting and selection
E type software can modify laser default parameter setting and selection in the option of
"Parameter setting" and "Parameter selection". The parameter settings take effect immediately
and save automatically after power down.
File Number: J-SI-0036
20