JL Audio Dominion d110 Owner's Manual page 22

STEREO RECEIVER
SPEAKER
OUTPUTS
+ +
– L – R
(L) (R)
TO SATELLITE
SPEAKERS
STEREO RECEIVER
SPEAKER
OUTPUTS
+ +
– L – R
WARNING! TURN OFF THE Dominion®(s) AND ALL OTHER EQUIPMENT IN
THE SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
EN | Page 22
DOMINION™ REAR PANEL
OR OR
DOMINION™ REAR PANEL
SYSTEM CONNECTION DIAGRAM 5:
Connecting one Dominion® to a
Receiver via the Speaker Level Inputs
The Dominion® features speaker level
inputs designed to accept the output of an
amplified source, such as a stereo receiver's
speaker outputs. The use of this feature is
only recommended when no suitable line-
level signal is available.
HIGH LEVEL
When connecting a single Dominion® in
INPUT PLUG
mono to a two-channel receiver's speaker
CH. 1 CH. 2
(L) (R) outputs, you will use both the Left and
Right connections on the "Speaker Level"
inputs plug of the Dominion®. Use good-
quality speaker cables (up to 12 AWG / 3
mm ) to make these connections. Make
2
sure you capture all the wire strands in
each connector port and do not allow any
of these wires to short together.
You can make the connections to
the Dominion® subwoofer's inputs at
the receiver's output terminals, or at
the main speakers, whichever is more
convenient. On receivers with A/B speaker
circuit selectors, you can connect the
Dominion® to the "B" outputs, giving
you the ability to easily switch the
subwoofer's signal on and off with the
receiver's speaker circuit selector switch.
The input section of your Dominion®
TO SATELLITE
SPEAKERS
will sum the left and right inputs to mono
and apply low-pass filtering to feed the
(R) (L)
subwoofer's internal amplifier when the "LP
Filter" of your Dominion® is switched "on."
Because the main speakers are
HIGH LEVEL
INPUT PLUG
being fed in parallel with the inputs
of the Dominion®, they continue to
CH. 1 CH. 2
(L) (R)
operate as full-range speakers. Any
adjustment of the "LP frequency (Hz)"
knob will only affect the sound of the
Dominion®, not the main speakers.
WARNING
| Dominion
®