KitchenAid Vertigo Integrated Series Installation Manual page 20

4. PANELS MOUNTING
> It is now possible to align panels to adjacent
cabinets in height using the lower alignment bra-
[ 3 ]
ckets, tightening or untightening the screws
into position as needed. With the screw slighty
tightened, move the panel sideways to align it
to the other panels on the unit or other adjacent
structures.
3
>
Depth alignment: working from the inside of the
drawer, after lifting up the magnetic seal, adjust
the panel position so it is closer to or further
away from the door using the holes
secure the panel using the holes
> Hook the panel to the fixing devices starting
from the top aligning brackets
6
20
[ 4 ] and then
[ 5 ].
4
5
[ 6 ].
> At this point, alignment between the panel and
adjacent cabinets can be adjusted using the ali-
gnment brackets and small brackets
>
Vertical alignment: tighten or loosen the screw
in the brackets to raise or lower the panel
9
> Depth alignment: working from the inside of the
door, after lifting up the magnetic seal, adjust the
panel position so it is closer to or further away
from the door using the holes
the panel in position using the holes
Once the front panel has been adjusted,
check that the gasket has been repositioned
correctly to assure the door/drawer are
closing correctly and avoid operational
errors of the unit.
[ 7] [ 8 ].
and
7
8
[ 9 ].
[ 10 ] and then fix
[ 11 ].
10
11