General Site Guidelines; Qfx5120 Site Electrical Wiring Guidelines; Table 22: Site Electrical Wiring Guidelines - Juniper QFX Series Hardware Manual

Hide thumbs Also See for QFX Series:
Table of Contents

Advertisement

QFX5110 Switch Hardware Guide

General Site Guidelines

QFX5120 Site Electrical Wiring Guidelines

Table 22: Site Electrical Wiring Guidelines

Site Wiring Factor
Signaling limitations
Radio frequency
interference
58
Efficient device operation requires proper site planning and maintenance and proper
layout of the equipment, rack or cabinet (if used), and wiring closet.
To plan and create an acceptable operating environment for your device and prevent
environmentally caused equipment failures:
Keep the area around the chassis free from dust and conductive material, such as
metal flakes.
Follow prescribed airflow guidelines to ensure that the cooling system functions properly
and that exhaust from other equipment does not blow into the intake vents of the
device.
Follow the prescribed electrostatic discharge (ESD) prevention procedures to prevent
damaging the equipment. Static discharge can cause components to fail completely
or intermittently over time.
Install the device in a secure area, so that only authorized personnel can access the
device.
Table 22 on page 58
describes the factors you must consider while planning the electrical
wiring at your site.
WARNING:
It is particularly important to provide a properly grounded and
shielded environment and to use electrical surge-suppression devices.
Guidelines
If your site experiences any of the following problems, consult experts in electrical surge
suppression and shielding:
Improperly installed wires cause radio frequency interference (RFI).
Damage from lightning strikes occurs when wires exceed recommended distances or pass
between buildings.
Electromagnetic pulses (EMPs) caused by lightning damage unshielded conductors and
electronic devices.
To reduce or eliminate RFI from your site wiring, do the following:
Use a twisted-pair cable with a good distribution of grounding conductors.
If you must exceed the recommended distances, use a high-quality twisted-pair cable with
one ground conductor for each data signal when applicable.
Copyright © 2019, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

Table of Contents