Fan Motor - Hisense HRF266N6CSE Service Manual

Fan Motor

Rated Voltage:
Freezer Fan: DC12V
Condenser Fan: DC12V
Check the Fan Motor
Mainboard Wiring Connection
Make sure the wiring connection between the
fan motor and mainboard is secure. If the wiring
connection is loose, repair the connection.
The Freezer fan motor corresponds to Pins No.
13~15 on the CN4 connector of the mainboard.
•
Pin No. 14 connects 12V power.
•
Pin No. 13 connects the Ground.
The Condenser Fan Motor: Corresponds to Pins
No. 1~2 on CN4 connector of the mainboard.
•
Pin No. 2 connects 12V power.
•
Pin No. 1 connects the Ground.
If the fan motor works normally, replace the
mainboard.
If the fan motor does not work normally, replace
the fan motor.
Remove the Freezer Fan Motor
1. Unplug the refrigerator or disconnect power.
2. Remove the Freezer Drawer. See "Drawer
Removal."
3. Using a Phillips screwdriver, remove the two
screws fastening the air duct.
4. Disconnect the wire harnesses, and then
remove the air duct.
5. Using both hands and a screwdriver, pry up the
rear clapboard part at the buckles, and then
remove.
6. Pull the freezer wind channel component from
its compartment, as shown.
7. Separate the wind channel cover from the
foam.
8. Using a Phillips screwdriver, remove the three
screws securing the fan, and then remove the
fan motors.
34