Start Fault - Hisense HRF266N6CSE Service Manual

Ice and Water
PROBLEM POSSIBLE CAUSE(S)
The ice Ice maker is not turned on.
maker is not
producing ice,
New installation
enough ice,
or cubes are
hollow
The water line is not connected or
the water valve is not open.
The freezer temperature is set too
high.
Ice in the ice bin is blocking the
action of the ice maker.
Kink in the water line
Inadequate water pressure
The water The water line is not connected or
dispenser is the water valve is not open.
not functioning
The water line is crushed or kinked.
The refrigerator temperature is
set too low and the water tank is
frozen.
The water filter is not properly
installed.

Start Fault

Is the power cord plugged
Is mainboard output power OK?
Check connectors and sensors
Start
into the outlet?
Y
Are mainboard
terminals connected?
Y
Y
Is the compressor OK?
Y
SOLUTION
Press the Ice On/Off control to turn On/Off the
ice maker. See "Display Controls."
Wait 12 hours after installation for ice production
to begin.
Connect the water line and turn the water valve
to the fully open position.
Lower the temperature of the freezer
compartment.
Break up or remove large clusters of ice cubes.
Replace water line.
Contact a licensed, qualified plumber.
Connect the water line and turn the water valve
to the fully open position.
Ensure the water line is free and clear from any
obstruction. Replace the water line if it has been
damaged.
Raise the temperature of the refrigerator
compartment.
Remove and reinstall the water filter.
N
Plug in the power cord
N
Plug in the terminals
N
Replace the mainboard
N
Replace the compressor
26