Hisense HRF266N6CSE Service Manual page 7

8. Using both hands, lift the door off the bottom
hinge and set it onto a soft surface to protect
the finish.
9. If necessary, use a hex-key wrench to remove
the two bolts fastening the bottom hinge to
the front of the cabinet, and then remove the
hinge.
10. Repeat this procedure to remove the other
door.
Remove the Front of the Freezer Drawer
1. Slide open the freezer drawer to its full
extension.
2. Slide open the upper storage drawer to its full
extension.
a
Upper storage drawer
3. Remove the ice bin from the upper drawer by
lifting up and pulling out at an angle.
a
4. Remove the upper storage drawer from the
glide rails by lifting up and pulling out at an
angle.
a
Upper storage drawer
5. Remove the lower storage compartment by
lifting upward at an angle.
a
Lower storage compartment
a
a
Ice bin
a
a
6. Using an 8 mm socket wrench, remove the
4 screws (2 on each side) attaching the
supporting frame to the brackets on the
interior panel of the drawer front.
a
Supporting frame
7. Using both hands, grasp the bottom of the
drawer front. Pull the bottom of the drawer
front toward you while lifting up to remove.
8. Set the drawer front on a soft surface to
protect the finish.
9. Slide the drawer glide rails into the cabinet.
10. Move the refrigerator through the doorway
and into the room near the water and electrical
connections.
Replace the Freezer Drawer
To reinstall the drawer after moving the appliance
to its final location, assemble the parts in reverse
order.
Replace the Doors
1. If removed, reinstall the bottom hinge.
2. Using two or more people, set the refrigerator
door onto the bottom hinge.
3. Insert the top hinge into the top of the door.
4. Using the three screws removed earlier, fasten
the top hinge to the top of the cabinet.
NOTE: Left-hand door only, replace the ground
screw into the top hinge, and then reconnect
the wiring harness.
5. Repeat steps 1 through 4 to replace the
opposite door.
6. Using the three screws removed earlier, reinstall
the top hinge cover and control panel to the
top of the cabinet.
7
a