Compressor Inverter Board - Hisense HRF266N6CSE Service Manual

Compressor Inverter Board

Remove Compressor Inverter Board
1. Unplug the refrigerator or disconnect power.
2. Remove the machine compartment cover to
access the inverter housing.
3. Remove the screw fastening the cover to the
inverter housing.
4. Remove the screw fastening the inverter
housing to the compressor.
a b
a
Housing cover screw
b
Housing screw
5. Remove the two screws from the wire clamps,
and then remove the three wires from the
inverter board.
6. Unplug the white molded wire connector from
the compressor pins.
a
b
a
Wire clamp screws (2)
b
Wires (3)
c
White molded wire connector
7. Unplug the ground wire connector from the
compressor.
a
8. Lift straight up on the inverter housing and
slide it to the left.
Reassemble Inverter Board
1. Plug ground wire from inverter board into
ground connection on compressor.
2. Align the rear angled piece with the slot on the
board cover.
3. Fit the inverter board housing onto the angled
bar above the compressor terminals.
4. Fit the front of the inverter board cover behind
the screw hole bracket.
a
b
c
a
b
c
d
e
33
Ground wire connector
c
d
Ground connection
Angled piece
Angled bar
Compressor terminals
Screw hole bracket
a
e