Table of Contents
Advertisement
Plug the Power pack into a power point and into the power socket of the NB5580W.
Connect your ADSL line (Telephone line) into the ADSL socket of the NB5580W.
Note: If your telephone line has an ADSL splitter installed you must connect the
NB5580W to the line/wall socket designated for ADSL use. If your
Telephone line does not have an ADSL splitter you must connect
Microfilters in-line with each telephone device you intend to use on the
Telephone line. See the Section on ADSL Filters / Splitters in the Appendix
of this manual.
Connect your computers (with Network Interfaces) to any of the four Ethernet LAN
sockets on the back of the NB5580W. If you wish to connect more than four computers
you should connect one of the LAN sockets to your Network Hub or Switch. Check
that the Ethernet sockets used have their respective LAN link lights on.
Note: Auto MDI is available on all four ports. A special cross over cable or
"uplink" port to join the router to another hub or switch is not required as
the NB5580W ports are self adjusting.
You should now be able to access and configure the NB5580W via a web browser. See
the Configuration section of this manual for more information.
Rev.1 - YML686
NB5580/W User Guide
www.netcomm.com.au
Page 15
Advertisement
Table of Contents
