Installing Your Ups System - Njoy Token Series User Manual

Installing your UPS system

4
4.1 Hardware installation guide
1. Placement & Storage conditions
Install the UPS in a protected area that is free of excessive dust and
has adequate air flow. Please place the UPS away from other units at
least 20 cm to avoid interference. Do NOT operate the UPS where the
temperature and humidity is outside the specific limits. (Please check the
specs for the limitations.)
2. Connect to utility and charging
Plug in the AC input cord to the wall outlet. For the best results, suggest
to charge the battery at least 6 hours before initial use. The unit charges
its battery while connecting to the utility.
3. Connect the loads
Plug in the loads to output receptacles on the front panel of the UPS.
Simply turn on the power switch of UPS unit, then devices connected to
the UPS will be protected by UPS unit.
CAUTION
Due to its high-power consumption, we do NOT recommend
connecting LASER PRINTERS or loudspeaker equipment
such as SUBWOOFERS to this type of UPS.
Do NOT plug any SURGE STRIPS into any of the outlets.
4. Connect communication cable
To allow for unattended UPS shutdown/start up and status monitoring,
connect the communication cable one end to the USB port and the other
to the communication port of your PC. With the monitoring software
installed, you can schedule UPS shutdown/start up and monitor UPS
status through PC.
8