Table of Contents
Advertisement
2.5. UPS installation for parallel system
If the UPS is only available for single operation, you may skip this section to
the next.
Step 1.
Install and wires the UPS according to the section 2.3
Step 2.
Connect the output wires of each UPS to an output breaker.
Step 3.
Connect all output breakers to a major output breaker. Then this
major output breaker will directly connect to the loads.
Step 4.
Common battery packs or independent battery packs are
allowed.
Step 5.
Refer to the following wiring diagram:
Wiring diagram of parallel system for Ranger 60KT
Check section 3.5. for Parallel operation of UPS.
2.6. Software installation
For optimal computer system protection, install UPS monitoring software
from https://www.power-software-download.com/viewpower.html.
14
3
Operations
3.1. Initial operation
Step 1.
Before operation, make sure that the two strings of batteries
are connected correctly in order
of the battery pack is at "ON" position (only in case of external battery packs
presence).
Step 2.
POWER button to set up the power supply for the
Press the
UPS. UPS will enter to power on mode. After initialization, UPS will enter to
"No Output mode".
3.2. Screen description
After initialization, the LCD will display main screen.
There are five sub-menus: Control, Measure, Setting, Information and Data log.
Touch any sub-menu icon to enter into the sub-screen.
ON/OFF UPS
Battery test
Control
Mute all
ON/OFF charger
Measure 1
Measure
Measure 2
Measure 3
Main
Setting
General
Advance
Save setting
Basic info
Info
Rated info
Parameter info
Data Log
of "+,GND,-" terminals and the breaker
Electrical
Battery
Miscellaneous
User mode
Password: 0000
Basic 1
Maintaner mode
Password: ****
Basic 2
SYS parameter
User
Install info
Maintainer
VOL CALLI
CURR CALLI
Initial
Data log
Electrical
Parameters
Battery
Calibration
Miscellaneous
EEPROM
UPS self-test
15
Touch
Advertisement
Table of Contents
