Endprüfung - Thermo Scientific Heraeus Multifuge X3 Manual

Table of Contents

Advertisement

2.7
Endprüfung
ACHTUNG!
Eine Endprüfung muss nach jeder Wartung und/oder Reparatur durchgeführt
werden! DIN EN 61010, IEC 61010, VDE 700/701
• Schutzleiterwiderstand prüfen
Zwischen Netzstecker-Schutzleiter und den Schutzleitern des Motors, des
Elektronik-Chassis und des Gehäusebodens darf der Meßwert nicht über 200
mΩ liegen.
Achtung! Der Motor hat keinen Schutzleiteranschluss. Die „rote" Ader ist ein
Potentialausgleich.
Isolationswiderstand prüfen
Prüfen Sie ebenfalls den Isolationswiderstand zwischen den Netzsteckerpolen
und dem Schutzleiter; er muß größer als 2 MΩ sein
Körperstrom nach IVD Medizingeräte Verordnung messen
Der Körperstrom darf im Fehlerfall (unterbrochener Schutzleiter) nicht größer
sein als 0,5 mA
L (N)
N (L)
PE
Ausgabe / Edition: 01
18.12.08 he/MW
Product Support
Steckergehäuse / plug-in casing
0,22µF
±5%
0,022µF
500Ω
±1%
Körperstrom:
accessible current: I [mA] = U [mV] / 500:
U
max
2 - 13
2.7
Electrical Safety Check
ATTENTION!
A final electrical safety check must be performed after each maintenance
and/or repair!
• Resistance check of protective conductor
The measuring value of the resistance between the mains plug's grounding pin
and the grounding conductors of the motor, electronic chassis and the casing
must not exceed 200 mΩ
Caution! The motor doesn't have PE connection. The red wire is only potential
equalisation.
Insulation resistance Check
Check also the insulation resistance between the poles of the mains plug and
the grounding conductor; the resistance value must be more than 2 MΩ
Accessible current measured to IVD medical equipment regulation
The accessible current must not exceed 0.5 mAmps in single fault condition
(interrupted protection earth wire)!
10kΩ
±5%
V
AC
±5%
= 250mV
I
= 0,5mA
max
Spezifaktionen für Meßgerät
- TRMS, DC - 5kHz oder mehr
Ω
- Eingangswiderstand > 1M
- Toleranz 5% oder besser
- Crest Faktor 5 oder besser
Specifaction for the meter
- TRMS, DC - 5kHz or more
Ω
- Input resistance > 1M
- Tolerance 5% or better
- Crest Factor 5 or better
Multifuge X3 & versions

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents