Safety - Finish Thompson SF Series Operations & Parts Manual

1. Introduction
This manual contains all the information needed for the correct installation, use and maintenance of your new Finish Thompson
pump and accessories. It should be read and understood by all the personnel involved in installation, operating and servicing of
the pump before it is started.
2. Operator Qualification and Training
The personnel in charge of the installation, the operation, and the maintenance of the pump must be qualified and able to per-
form the operations described in this manual. Finish Thompson, Inc. shall not be held responsible for the training level of
personnel and for the fact that they are not fully aware of the contents of this manual.
3. Safety Instructions
FOR YOUR OWN SAFETY
BEFORE using or servicing your pump or accessories, please make sure to wear the proper clothing, eye protection and follow
standard safety procedures when handling corrosive or personally harmful materials.
GENERAL DANGER
NEVER use a plastic pump, plastic accessory, or an open, splash-proof, TEFC or non-ATEX motor when pumping or mixing flam
mable or combustible material.
ALWAYS ensure the pump, hose, and motor are bonded to ground, and the tanks/containers are separately bonded to ground.
ALWAYS inspect the integrity of the ground wire connections prior to each use.
NEVER leave the pump unattended while in use.
NEVER run the pump dry without fluid.
NEVER run the pump with a closed valve (deadhead) for longer than 1 minute.
ALWAYS use and store the pump and motor in an upright position.
NEVER use in pressurized containers.
ALWAYS use a chemically compatible hose rated for the temperature of the product being pumped.
ALWAYS tighten and torque a stainless steel hose clamp to 25 in-lbs (2.8 N·m)
ALWAYS select the proper o-ring material. Improper material selection could lead to swelling and be a possible source of leaks.
This is the responsibility of the end user.
ALWAYS check the pump for leaks on a regular basis. If leaks are noticed, the pump must be repaired or replaced immediately.
DANGER: POWER SUPPLY
Refer to instructions in the appropriate motor Operation & Installation Manual.
4. Noise Level
Refer to specifications in the appropriate motor Operation & Installation Manual.
5. Modifications and Spare Parts
Any changes concerning the service of the pump or accessory as originally purchased can be executed only after written
approval from Finish Thompson Inc. It is recommended to use only genuine Finish Thompson Inc. spare parts and approved
accessories. The use of non-original spare parts or non-approved accessories will void warranty and removes any responsibility
on the manufacturer's behalf for any damage caused to people or things.
6. Cleaning
It is highly recommended to flush pumps and accessories with clean water or some other neutralizing fluid compatible with
pump materials when done pumping or when switching chemicals.

Safety

5