Mounting The Tilt Mount; Figure 11: Tilt Mount Base - Plate View; Figure 12: Tilt Mount Base - Side View - FGD FlameSpec UV-IR-HD User Manual

FlameSpec UV-IR-HD User Manual
The tilt mount enables the detector to be rotated up to 45 degrees (horizontal/vertical) in all
directions. The following installation instructions show how to use it to support the detector from
below (the preferred method).
To install the tilt mount:
a) Mount the tilt mount base ( Figure 11: Tilt Mount Base - Plate View ) to a solid structure using
four suitable fixings through the four 7mm (0.28") diameter holes. Four captive screws with
spring washers are provided in the tilt mount.
For more information & technical support: (+1) 714-671-8500 · support@fg-detection.com

Mounting the Tilt Mount

Figure 11: Tilt Mount Base - Plate View

Figure 12: Tilt mount base – Side View
F130V0020.06
12