Installing The Tilt Mount; Figure 1: Tilt Mount Base - Rear View - FGD FlameSpec IR3-H2-HD User Manual

FlameSpec IR3-H2-HD User Manual

2.5 Installing the Tilt Mount

The tilt mount enables the detector to be rotated up to 45 degrees (horizontal/vertical) in all
directions. The following installation instructions show how to use it to support the detector from
below (the preferred method). However, with a designated adapter the tilt mount can hold the
detector from above. Other designated adapters may be used to connect the detector to some other
vendors' tilt mounts (useful when replacing an existing detector).
To install the tilt mount:
a) Place the tilt mount (Fig. 1) in its designated location and secure it with four screws through four
0.28" (7mm) diameter holes. There are four captive screws with spring washers in the tilt mount.
The following drawing shows the location of the four holes for the screws and washers.
For more information & Technical support: (+1) 714-671-8500 · support@fg-detection.com

Figure 1: Tilt Mount Base - Rear View

F140V0020.03
7