Mounting The Detector; Figure 13 - Detector On Tilt Mount - Side View - FGD FlameSpec UV-IR-HD User Manual

FlameSpec UV-IR-HD User Manual
Use the following steps to connect the detector to the tilt mount, referring to Figure 13 :
a) Place the detector, with its cable/conduit entries pointing down, on the holding plate of the tilt
mount (item 2).
b) Secure the detector to the plate using the two hex screws and spring lock washers (items 3
and 4).
c) Loosen the locking screws (Items 5 and 6) in such a way that enables you to rotate the
detector.
d) Point the detector towards the detection area and make certain that the view of the area is
unobstructed.
e) Secure the detector in that position by tightening the locking screws (Items 5 and 6) on the tilt
mount. (Make sure the detector is pointing in the correct direction).
The detector is now correctly mounted, aligned and ready for electrical connection. Please refer
to section 2.7 for wiring instructions, and section 3 for a description of the detector's configuration
settings.
ITEM
NO.
1
2
3,4
5
6
For more information & technical support: (+1) 714-671-8500 · support@fg-detection.com

Mounting the detector

F 13 - D
IGURE ETECTOR ON
TILT MOUNT ASSEMBLY
HOLDING PLATE
MOUNTING HEX SCREWS M8 AND LOCK WASHERS
HEX SOCKET LOCKING SCREW M8
HEX SOCKET LOCKING SCREW M12
F130V0020.06
T M – S V
ILT OUNT IDE IEW
ITEM NAME
13