Loading Products - VendNet ST 3000 Service Manual

Single temp/variable temp glass front vendor
Table of Contents

Advertisement

LOADING PRODUCTS

Load products from front to back making sure all items fit freely between the spiral spaces. Do not attempt to force oversize items or
packages into the spaces. Do not skip a space. Place the product on the bottom of the compartment on the product spirals with the label
facing the front of the vendor for easy identification by the customer. See Figure 9.
SNACK/CANDY/FOOD TRAY OPTION
To load products, lift the tray slightly and pull forward until the tray stops. The trays tilt for
easier loading.
The size of the item being vended must be larger than the diameter of the spiral being used to
vend properly.
Undersized items could cause vend problems. If the product does not fit the spiral properly, use
a different pitched spiral. Call the number located within this manual for spirals available from
your distributor or service entity.
CAN/BOTTLE TRAY OPTION
To unlatch the Can/Bottle Trays place both hands with your palms up ... then push out simultaneously with your thumbs depressing the
slide left and right side latches and pullout as shown (See Fig 10). Carefully load products vertically as shown. Some bottle and/or can
containers present and vend better by using the provided spiral risers. If the product requires additional vertical space or presents/vends
poorly remove the risers as necessary.
HIGH CAPACITY CAN TRAY (HCCT) OPTION
Some vendors come equipped with the HCCT option. There are two setups for
the HCCT option ... one for vending 355ml (12oz.) and one for 375ml (13oz.)
cans. The HCCT option is only provided for these two can sizes with identical
diameters. Load product horizontally from front to rear and stack a maximum
of three (3) levels high. See Figure 11.
Install a display can in the area provided in front of each selection as shown.
Adjust the price scrolls to the desired price.
S T / V T V E N D O R • 3 5 6 8 3 5 6 7 3 5 6 6 3 5 6 5 •
Push out on latches
with thumbs
Figure 10. Tray Latches
Pull out
on tray to
load
Spiral Risers
Figure 11. High Capacity Can Tray OPTION
8
Figure 9. Loading Products
Load cans
horizontally up to
3 high as shown
Load display cans
as shown in front
of each selection
4 2 2 0 5 5 7 R E V A

Advertisement

Table of Contents
loading

Table of Contents