Table of Contents
Advertisement
SALES MODE
The vendor automatically defaults to Sales Mode after it is turned on. In the Sales Mode, the vendor accepts money deposits, pays out
change and dispenses product to the customer.
DISPLAY CREDIT - ELECTRONIC PRICING
This vendor is equipped with the Electronic Pricing feature. The customer may verify the price by pressing the selection number (i.e. 22)
before inserting money. If a selection is made and credit has not been established, the price for that selection is displayed and "INSERT
MORE MONEY" will be displayed. When money or credit is accepted, then the amount of credit is displayed.
"USE EXACT CHANGE ONLY" MESSAGE OPERATION
If the coin levels in the coin mechanism tubes are below the low-level sensors, "USE EXACT CHANGE ONLY" will be displayed. This
indicates the Coin Mechanism does not have enough coins in the coin mech tubes to make change. This also indicates that the Dollar Bill
Validator may be disabled until change can be made.
BASIC PROGRAMMING SETUP
This portion of the manual includes only basic Service Mode Programming functions. Refer to the CONTROL SYSTEM Programming Manual
included with the vendor for more advanced description of all functions within the Service Mode.
KEYPAD
Use the buttons on the keypad as directed in the step-by-step instructions in this manual to program the vendor.
Entries from the keypad will be displayed on the front vendor display.
DISPLAY
Check the display after pressing
the Service Mode Button and/or
Keypad Buttons to make sure
that the program is responding
correctly.
SERVICE MODE
Use the Service Mode to program and service the
vendor. Use the keypad as an input device. Watch
the display for information while in Service Mode.
SERVICE MODE BUTTON
To enter Service Mode, press the Service Mode
Button located on the top or upper right corner of
the controller cover (See Figure 19). To exit Service
Mode, press the Service Mode Button.
NOTE:
If no key is pressed for approximately one
minute while in Service Mode, the controller will
automatically return to Sales Mode.
S T / V T V E N D O R • 3 5 6 8 3 5 6 7 3 5 6 6 3 5 6 5 •
Buttons 0-9 are used to
move between the various
modes, menus and sub-
menus; while the
button is
used to enter a menu,
confirm or save a setting.
See Figure 18
FIG 19. : Service Mode Button
14
FIG 18.: Keypad Layout
Service Mode
Button
Board Power
LED
OPTIONAL DEX
Jack
MDB Status
LED's
4 2 2 0 5 5 7 R E V A
Advertisement
Table of Contents
