Automatic Delivery Lift - VendNet ST 3000 Service Manual

Single temp/variable temp glass front vendor
Table of Contents

Advertisement

Loading Coin Mechanism
INSERT COINS THROUGH
The Coin Mechanism must be loaded with some level of each coin in
FRONT DOOR COIN
order for the vendor to operate properly. The coins need to be
PRESS SERVICE
INSERT TO FILL COIN
loaded into the coin mechanism by insertion into the front coin
MODE BUTTON
TUBES
insert. First enter the SERVICE MODE then TUBE FILL MODE
AND PRESS 1 TO
(See SERVICE MODE instructions – COIN/TUBE FILL MODE
ENTER TUBE FILL
Each tube should be kept loaded with at least one roll of each coin
MODE
to keep above the tube low level sensors. Once the tubes are loaded
to these levels the Dollar Bill Validator will accept bills. If the coin
tubes fall below this level the Dollar Bill Validator may stop
accepting bills and the front display will indicate "EXACT CHANGE
ONLY".
Alternatively, you can load the coins into the slots above the respective coin tubes, making sure to load the
correct coins into their correct tubes. This is not the preferred method. By using TUBE FILL mode the control board can then accurately
determine coin levels.
On some Coin Mechanisms there are buttons above each tube to dispense the coins (may vary depending on which coin mechanism that is
used). The coins can also be dispensed within the Service Mode described later.
Bill Validator Operation
(OPTIONAL)
To remove the bills from the Dollar Bill
Validator push the tab on the top of the
bill box and lift up. To clear jams or
cleaning unlatch lower unit as shown.
Dollar Bill Validator cleaning instructions
as well as more advanced service
information can be obtained on the
Service portion of the website listed at
the beginning and end of this manual.
AUTOMATIC DELIVERY LIFT (OPTIONAL)
This information is for machines with the GVC2 Control Board (part number 4214682.004) and software version V3.3.10177 and higher.
INTRODUCTION
The Automatic Delivery Lift system is designed to lift vended products to the 2012 American Disabilities Act (ADA) height requirement level
from the locations floor. This same system can also provide an enhanced customer experience for those locations where an almost hands
free vended product presentation is desirable.
The Delivery Lift system is an option that can be used on the line of Delivery Lift Ready Machines (also called ADA ready machines) and
consists of an LED illuminated product delivery box with a motorized product lift plate, a set of product height sensors, a motorized delivery
box door (Auto Door) and a Blue LED illuminated activation button.
The delivery lift system can be factory installed or provided as a retrofit kit for field ADA ready machines. See the list of ADA ready model
numbers or contact a sales or service representative for more information.
INITIAL SETUP – SERVICE MODE
When an Automatic Delivery Lift system is installed in an ADA ready machine, it is automatically detected when a controller Service Mode
Motor Count is done. The Motor Count will show the tray motor count briefly with the 3 additional delivery lift motors before returning to
a tray motor count only. Once a Delivery Lift system is detected, it will complete a functional test at every Motor Count or at machine
power on. When the Delivery Lift is moving, the Blue Delivery Lift Button on the front of the machine will flash and can be pressed to stop
the Delivery Lift operation if necessary. Information on Service Mode Configuration menu and Diagnostic Mode menu options are listed on
the following pages.
SALES MODE
When a product is selected and vended, the product drops into the Delivery Lift Box after it first passes by the iVend sensor to confirm that
a product has been vended. Next, when the machine is using the default BUTTON configuration mode, the Blue Delivery Lift Button will be
constantly illuminated for 10 seconds, during this period the Delivery Lift can be activated. When the illuminated button is pressed, the
Delivery Door will open, the Delivery Lift will begin raising the vended product and the button will flash. The product will be raised until a
12
S T / V T V E N D O R • 3 5 6 8 3 5 6 7 3 5 6 6 3 5 6 5 •
4 2 2 0 5 5 7 R E V A

Advertisement

Table of Contents
loading

Table of Contents