Main Harness - Haier GE GFD14ESSNWW Technical Service Manual

5. Remove the four 8-mm motor bracket clamp
mounting bolts and remove motor from motor
bracket.
Take note of the tension spring mounting location.
Tension
Spring
– 43 –

Main Harness

The main harness is available for replacement, if
necessary.
NOTE: The sensor rods, sensors, float switch,
and heater have their own harness with
connectors. If the harness or connector is faulty,
the part would have to be replaced.
Main Harness Removal
1. Remove control panel, control panel
mounting bracket, top cover, front panel, front
drum support and drum (see Control Panel
and Front RJ45 Access, Top Cover, and
Front Panel sections of this service guide).
2. Disconnect the harness connectors from the
components.
3. Cut the wire ties securing the harness, and
unroute the harness for removal.
NOTE: When rerouting harness, make sure to
replace any wire ties cut during harness removal.