Installation In Mobile Home; Electrical Connections; Requirements And Instructions - Haier HLF103Q Service Manual

C
I

Installation in mobile home

Dryer must be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support
combustion. Metal ducting must be 4 inches (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred.
If dryer is exhausted through the floor and area beneath the mobile home is enclosed, the exhaust system must
terminate outside the enclosure with the termination securely fastened to the mobile home structure.
Refer to previous pages for other important venting requirements.
Installation must conform to current Manufactured Home
Construction Safety Standard(which is a Federal
Regulation Title 24 CFR-Part 32-80) or when such standard
is not applicable, with American National Standard for
Mobile Homes.
Warning: the dryer is designed under
ANSI z 21.5.1 for home use only.
DO
Correct
E

Electrical connections

C
C
R

Requirements and instructions

Warning: the following are specific requirements for proper and safe electrical installation of
your dryer. Failure to following these instructions in this manual for proper grounding.
1. This appliance MUST be properly grounded. Electrical shock can result if the dryer is not properly grounded. Follow
the instructions in this manual for proper grounding.
2. Do not use an extension cord with this dryer. Some extension cords are not designed to withstand the amounts of
electrical current this dryer utilizes and can melt, creating electrical shock and/or fire hazard. Locate the dryer within
reach of the receptacle for the length power cord to be purchased, allowing some slack in the cord. Refer to the
pre-installation requirements in this manual for the proper power cord to be purchased.
3. A U.L. approved strain relief must be installed onto power cord. If the strain relief is not attached, the cord can be
pulled out of the dryer and can be cut by any movement of the cord, resulting in electrical shock.
4. Do not use an aluminum wire receptacle with a copper wired power cord and plug (or vice versa). A chemical reaction
occurs between copper and aluminum and can cause electrical shorts. The proper wiring and receptacle is a copper wired
power cord with a copper wired receptacle.
DON'T
Incorrect
DO
Correct
DO
Correct
DON'T
Incorrect
DON'T
Incorrect