Antelope ISOCHRONE TRINITY User Manual page 32

APPENDIX C
Error messages explained:
CANNOt dA CHOSEN SOUГCE
● Display says: CANNOt dA CHOSEN SOUГCE
● Read: Cannot DA Chosen Source
● Reason: The Audio channel is set to DA, and SOURCE is set to either OVEN or
VIDEO.
● Solution 1: Continue in DA mode by changing SOURCE knob to a position
corresponding to a valid rear panel input.
● Solution 2: Leave DA mode, choosing an internal sample rate.
NO IПPUt
● Display says: NO IПPUt
● Read: No Input
● Reason: The Audio channel is set to DA, but there is no input on the chosen
SOURCE.
● Solution 1: Continue in DA mode by applying a valid rear panel input that
corresponds to the front panel SOURCE knob.
● Solution 2: Continue in DA mode by changing SOURCE knob to a position where
there is a valid rear panel input.
● Solution 3: Leave DA mode, choosing a standard sample rate.
SOURCE OFF-ГAtE
● Read: Source Off-Rate
● Reason: Input is a non-standard frequency that is not one of the recognized
gearboxing frequencies as in Appendix A and is likely a varispeed input frequency.
● Solution 1: Continue with the off-rate input and select SPLIT mode. The audio
channel must also be in DA mode.
● Solution 2: Change SOURCE knob to OVEN and run on internal clock.
Isochrone Trinity User Manual 32