3.
Arrange a busbar, contact X0, and G_stLinkIEF.bnRX[H3F] in the program editor, and link them to Enable of the FB.
4.
Link Axis information to the left side of the FB. Link the output to the right side of the FB.
5.
Repeat these steps to create the ladder.
In this manual, the FB library provided by Mitsubishi Electric is used.
For how to set the FB library, refer to the following.
Page 19 Downloading the FB Library
Page 20 Importing the FB Library
5 CREATING PROGRAMS
5.5 How to Use the FB Library
5
46