Advertisement
The VideoMate 2300 can be genlocked into any video
system. In order to utilize the genlock feature, a
second video source, a video switcher box and the
appropriate input/output cables are required. We also
strongly recommend the use of a vector scope for the
best possible results.
Once genlock is connected, access the menu and
follow the step-by-step directions.
On-Screen Menu
MODE
H PHASE
SC PHASE
SC FINE
When an external sync signal is input, the display
mode changes from the factory set INT (internal sync)
to AUTO (external sync).
Changing AUTO Settings
To select the item you want to adjust, move the arrow
" " on the left side of the screen up and down by
pushing the FUNCTION UP, FUNCTION DOWN
buttons. Once you choose an item, you can change
the setting by pushing the DATA UP, DATA DOWN
buttons.
Adjusting the Horizontal Phase
1. Set the arrow " " to H PHASE by pushing the
FUNCTION UP, FUNCTION DOWN buttons.
2. Adjust the horizontal phase by pushing the DATA
UP, DATA DOWN buttons. The values range from
-99 to 99, DATA UP will increase the setting
towards 99 and DATA DOWN will decrease it
towards -99.
Coarse Adjustment of the Sub Carrier Phase
1. Set the arrow " " to SC 0/180 by pushing the
FUNCTION UP, FUNCTION DOWN buttons.
2. Select either 0 or 180 by pushing the DATA UP,
DATA DOWN buttons.
•
AUTO INT
0
•
0
180
0
15
Advertisement
