Advertisement
7 and 8 (Low Voltage Supply)
For operating external equipment. The current is
supplied by a secondary winding on the main motor,
isolated from the line-voltage power, and is available
whenever the main projector motor is running. Supply
is 25.5 V, 500 mA (1/2 A) maximum. Contact number
8 is common (return) for the remote-control circuit.
Contact number 7 is the "hot" lead and is fused with a
slow-blowing fuse. Replacement requires disassembly
of the projector by a qualified technician
6 and 8 (Forward Tray Cycle)
Connects to the forward tray-advance circuitry in the
projector. These contacts are connected internally to
the remote-accessory receptacle and an electrical
connection made at either receptacle will result in a
forward cycle.
2 and 8 (Reverse Tray Cycle)
Connects to the reverse tray-advance circuitry in the
projector. These contacts are connected internally to
the remote-accessory receptacle and an electrical
connection made at either receptacle will result in a
reverse cycle.
Shell (Plug Ground)
If a plug with a conducting shell is used, it is con-
nected to the projector frame (chassis) through the
special-application receptacle and to earth ground
through the projector's cable.
The EBY remote control connector is located in the
rear of your projector. This 5-Pin connector controls
zoom, slide forward and slide reverse via remote control.
14
Advertisement
