Advertisement
10
This system is designed to permit the use of previously
prepared presentations without requiring a reorientation
of slides.
For those setting up a new tray and/or presentation:
1. Arrange the slides in the order that they should
appear in the presentation. Arrange them so that
they are upright and reading correctly from left to
right.
2. Rotate each slide to turn the image upside down
(do not turn the slide over). Mark a sequential
number in the upper right corner of each slide (this
will be extremely useful if the slides ever become
mixed). Use a felt tip marker, rather than labels
that will be loosened by the heat.
3. Make sure that the bottom metal plate on the slide
tray is indexed into the zero position (the plate will
not rotate with respect to the top tray). Remove
the top lock ring by rotating it counter clockwise.
4. Insert slide #1 into slot #1. The number written on
the upper right corner of each slide should be at
the top and facing the next higher numbered slot.
Load all slides and replace and lock the top lock
ring.
1. Center the tray over the post on the projector.
2. Gently rotate the tray until the #0 slide slot is at
the index mark and the tray will drop into position.
If the tray does not drop into position, check to see
that the lower metal plate is locked in the zero
position (rotate until it locks).
To remove the tray from the projector without loosening
the slides:
1. Hold the selector bar down and rotate the tray
back to the zero index position.
2. Lift the tray at the point opposite the index mark.
Advertisement
