Advertisement
12
The VideoMate will function with either of the 85 watt,
82 volt lamps listed below. One provides a higher color
temperature, while the other exhibits a much longer life.
To prevent a severe "melt-down," do not use 250-
300 watt, 82 volt slide projector lamps.
L
a
m
p
#
V
l o
a t
E
S
H
8
2
E
S
* J
8
2
S *
a t
n
d
a
d r
a l
m
p
s
u
The entire illumination system is contained in a unit
called a lamp module. This module is a drawer type
configuration, which may be removed from the projector
to change the lamp.
Unfortunately, it takes 5 to 10 minutes to change the
lamp, because it must first be allowed to cool down.
Therefore, if timing is critical, you should keep a spare
lamp module on-hand in case a lamp burns out in the
middle of a presentation. Replacing the module takes
considerably less time than changing the lamp. Spare
lamp modules can be purchased. Please call for price
and availability.
To change the lamp:
1. If the unit has been running, switch the power to
FAN and wait 5 to 10 minutes for it to cool down.
2. Turn the power switch to OFF.
3. Press down on the door latch of the lamp module
and pull it slowly outward until the module clears
the projector.
4. Unclasp the wire bail, which holds the lamp in
place and push from underneath the lamp to slide
the lamp out of the receptacle.
5. Reverse the procedure to insert the new lamp
(make sure that the new lamp is properly seated).
6. Lock the new lamp into place with the wire bail.
g
e
W
t a
s t
8
5
2
8
5
p
p
e i l
d
i w
h t
V
d i
e
o
M
t a
i L
e f
C
l o
r o
T
5
0
. r h
2
9
5
0
4
0
. r h
3
3
5
0
. e
e
m
. p
K
K
Advertisement
