•
Turn counterclockwise the rod guiding screw (31) [take
care to the washer (32)] and check the seal inside the
screw (31) is undamaged.
•
Take out the screws (33) [take care of the washers (34)]
and remove carefully the cylinder (35) (do not bend it during
extraction in order to avoid that motor piston may damage
the internal surface of the cylinder).
Fig. 5N
•
Extract the motor piston from the motor support (36).
•
Verify the O-ring (37) is undamaged.
•
Tighten the lower edge of the piston rod using pliers (see
illustration) and unscrew the fitting (38) with a wrench.
•
Remove the motor rod (39) and check it is undamaged.
•
Rub the motor rod (39) with vaseline grease before inserting
it into the housing of the piston rod.
•
Tighten again with pliers the lower edge of the piston rod
and screw the fitting (38) (application of a sealant on the
thread is advisable).
ED. 01 - 09/2022 - Cod. 150206
31
32
37
36
OMEGA 5:1
IT EN
33
34
35
Warning:
tighten here
39
38
Fig. 6N
www.larius.com
49