Table of Contents
Advertisement
Available languages
Available languages
EN
EN
Holding and guiding the tool
Warning! While working, always hold the tool at the grey-coloured grip area(s).
- Always hold the tool firmly with both hands, so you will have full control of the tool at all times.
- Provide for a secure stance.
Warning! Do not apply so much pressure on the tool that it comes to a standstill.
- Keep ventilation slots (L) uncovered.
Maintenance and Care
WARNING! Before carrying out any work on the polisher, always pull out the mains plug.
Cleaning
• Regularly clean the power tool and ventilation slots. Frequency of cleaning is dependent on the material and duration of use.
• Regularly blow out the housing interior and motor with dry compressed air.
Carbon brushes
NOTE. Use only original parts supplied by the manufacturer for replacement purposes . If non-original parts are used, the guarantee obligations of the manu-
facturer will be deemed null and void. When the polisher is being used, the carbon brushes can be seen sparking through the rear air inlet apertures .
If the carbon brushes spark excessively , switch off the polisher immediately.
Take the polisher to a customer service workshop authorised by the manufacturer.
6
WWW.BORMANNTOOLS.COM
Advertisement
Table of Contents
