Replacing The Power Cable; Cleaning And Maintenance; Disposal And Recycling - BorMann BSS1800 Translation Of The Original Instructions

6.2 Working with the orbital grinder/sander
• Place the whole surface area of the sanding
disk on the material.
• Switch on the machine and move it with gentle
pressure over the workpiece completely circular
movements or moving it to and fro and up and
down.
• Use a coarse paper for coarse sanding and a
finer paper for finish sanding. You can find the
best paper for the job by means of testing.
Important.
The dust generated when working with the
machine may be harmful.
• Always wear goggles and a dust mask when
carrying out sanding/grinding work.
• Everybody who uses the machine or enters the
workplace must wear a dust mask.
• Do not eat, drink or smoke at the workplace.
• Do not use the machine on paints which
contain lead.

7. Replacing the power cable

If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
aftersales service or similarly trained personnel to
avoid danger.

8. Cleaning and maintenance

Always pull out the mains power plug before
starting any cleaning work.
8.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
16
• We recommend that you clean the device
immediately each time you have finished using it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can
seep into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.

9. Disposal and recycling

The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local
council.
10. Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 5 and 30 °C. Store the
electric tool in its original packaging