Table of Contents
Advertisement
4.6.4.2
Forces
The following forces and currents can be parameterized for the driving curve:
Continuous torque (power) OPEN
Continuous torque in the door position OPEN.
This parameter is effective when an open command is present and the door is in the OPEN
position.
The current generates a continuous torque against the end position of the door in the
opening direction.
Adjustment ranges
The parameter can be adjusted in accordance with the adjustment ranges of the parameters
(see Section Profiles and adjustment ranges (Page 100)). The value of the parameter must be
selected so that the door is held in the OPEN position.
Continuous torque (power) CLOSE
Continuous torque in the door position CLOSED.
This parameter is effective when a close command is present and the door is in the CLOSED
position.
The current generates a continuous torque against the end position of the door in the closing
direction.
Adjustment ranges
The parameter can be adjusted in accordance with the adjustment ranges of the parameters
(see Section Profiles and adjustment ranges (Page 100)). The value of the parameter must be
selected so that the door is held in the CLOSED position.
Cutter press-on torque
The peak torque close presses the door against the door endstop in the closed position.
If an obstruction is detected within a tolerance range of 1 cm around the CLOSED position,
then the cutter press-on torque is applied for approx. 2 seconds.
Adjustment ranges
The parameter can be adjusted in accordance with the adjustment ranges of the parameters
(see Section Profiles and adjustment ranges (Page 100)). The value of the parameter must be
selected so that the cutter force opposing the door is overcome, and the door is closed
completely.
SIDOOR ATD400T door control units for railway applications
System Manual, 06/2020, A5E42201947-AB
4.6 Operating and parameterizing controllers
Controllers
59
Advertisement
Table of Contents
