Table of Contents
Advertisement
SIDOOR SERVICE TOOL
7.3 Operation
Operating principle
Action
1
2
3
4
5
Note
Parameter changes are accepted with the door at a complete stop or in the OPEN or CLOSED
position.
Risk of injury due to moving mechanical parts
After changes to the parameters of the door the permissible energies and forces have to be
checked by service staff and adjusted if they exceed their limit values.
Menu navigation
You can find the menu navigation for the SIDOOR SERVICE TOOL in the section Navigation
structure in the SIDOOR SERVICE TOOL (Page 83).
82
Select required parameter
Activate parameter for setting
using the Return key
Increase or decrease parameter
value
Accept parameter value by press-
ing Return key again
•
Select the next parameter
(Step 1)
or
•
exit the menu
WARNING
Key
Remarks
Parameter value flashes
Displayed parameter value stops flashing
after acceptance.
-
SIDOOR ATD400T door control units for railway applications
System Manual, 06/2020, A5E42201947-AB
Advertisement
Table of Contents
