Table of Contents
Advertisement
Controllers
4.6 Operating and parameterizing controllers
4.6
Operating and parameterizing controllers
The service buttons can be used to operate the controller.
The following options are available to parameterize the controller.
1. Parameter assignment with the minimal editor
2. Parameter assignment with the terminal module
3. Parameter assignment via supplementary devices (SIDOOR SERVICE TOOL, SIDOOR
SOFTWARE KIT)
Note
After the optimal parameter settings have been determined, note them in the configuration
record (see Appendix Configuration record (Page 103)). Have this record to hand when you
call the Hotline.
Note
Parameter changes
Parameters should always be adjusted during normal operation with the door in the CLOSED
position, because the controller then accepts the values immediately.
4.6.1
Service buttons / Minimal editor
Overview
SIDOOR ATD400T
① 7-segment display
② Learn run button
③ Service button OPEN
④ Service button CLOSE
Figure 4-3
48
Overview of minimal editor
SIDOOR ATD400T door control units for railway applications
System Manual, 06/2020, A5E42201947-AB
Advertisement
Table of Contents
