Setup Troubleshooting; Additional Information - IBM eserver Cluster 1350 Installation And Service Manual

The setup procedures are documented in the Cisco Quick Start Guide Catalyst
3500 Series XL Switches:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35xu/3500.htm
After completing the First Time Setup section in the Cisco Quick Start guide, save it
to the startup file so the switch can be rebooted without losing the setup
configuration. At the telnet prompt, type the command:copy run start
The Quick Start guide also describes how to obtain the JAVA plug-in and configure
your browser to support the HTML interface.
There is an SNMP vulnerability for various versions of switch firmware.
See http://www.cisco.com/warp/public/707/cisco-malformed-snmp-msgs-pub.shtml
for specific firmware patches to download.

Setup troubleshooting

Once the initial setup is complete, there should be a network connection between
the PC and the switch. If a ping to the switch fails, make sure that the IP address
and gateway address to make sure the subnet and gateway addresses match:
v On the PC, at the command prompt, type: ipconfig
v On the switch, at the command prompt, type: show running x

Additional information

Catalyst 5000 Family Ethernet and Fast Ethernet Switching Modules Installation and
Configuration Note (including Translated Safety warnings 10 languages):
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/cnfg_nts/ethernet/5014etsm.htm#20508
Catalyst 3500 Series XL Hardware Installation Guide Includes Troubleshooting:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc/3500ig/index.htm
Catalyst 2900 Series XL and 3500 Series XL Cisco IOS Release 12.0(5.3)XU:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc/rn53/1061505.htm
Quick Start Guide Catalyst 3500 Series XL Switches:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35xu/3500.htm
62 IBM Eserver Cluster 1350 Installation and Service Guide