Replacement Of Netbay Advanced Connectivity Technology Remote Console Manager - IBM eserver Cluster 1350 Installation And Service Manual

1. Connect a laptop computer running a terminal emulation program (such as
2. Set the console terminal to:
3. Connect the LAN port in the console switch to an Ethernet hub being used as
4. Make sure that the power on the console switch is turned on. After
5. Get the IP address of the TFTP server. If you are using the SolarWinds TFTP
6. Right-click on Network Neighborhood, and select Properties.
7. Click the Protocols tab, and select TCP/IP protocol.
8. Select Properties, and make note of the IP address.
9. If necessary, assign the IP address for the console switch:
Replacement of NetBAY Advanced Connectivity Technology Remote
Console Manager
Detailed removal, replacement, and configuration information for the remote console
manager (RCM) is addressed in the applicable service manual that came with the
unit.
56 IBM Eserver Cluster 1350 Installation and Service Guide
HyperTerminal) to the configuration port on the back panel of the console switch
using a RS232 DB9 null modem cable.
v 9600 baud
v 8 bits
v 1 stop bit
v no parity
v no flow control
the TFTP server. Launch both the server software and the terminal emulation
software.
approximately 40 seconds, the console switch will send out a message reading:
Avocent AutoView 1000R/2000R Ready_Press any key to continue. Press any
key to access the AutoView 1000R/2000R main menu.
server, the IP address is shown in the lower right-hand corner of the server
pane. Otherwise, you must extract the IP address using Windows operating
system tools.
a. To select the network configuration, in the terminal emulation window, type
1.
b. Compare the remote console switch IP address to the TFTP server IP
address. The first 3 numbers of both IP addresses must be the same, but
the last number must be unique. If the console switch IP address is
incorrect, type 3 to select the IP address, and then enter the correct
address.
c. To exit network configuration, type 0 and follow the onscreen prompts to
upgrade the FLASH level on the console switch.