Resetting The Remote Supervisor Adapter Card; Checking Service Processor Logs; Management, Cluster, And Storage Node Problems - IBM eserver Cluster 1350 Installation And Service Manual

v m3-dist (has dependency on GM)
v Mute (has dependency on GM and m3-dist)
Comprehensive details on how to build the software is described in the:
v Linux README file
v GM mt/README file
v m3-dist README file
v mute software README file
Currently m3-dist and Mute compile against GM version 1.5. With GM version 1.4
the SNMP library does not build m3-dist or Mute. Build the software using GM
version 1.5.
You can access Myrinet software from: http://www.myri.com/scs/index.html (for GM,
select the LANai9 software).

Resetting the Remote Supervisor Adapter card

The Remote Supervisor Adapter (RSA) card is typically connected to a remote
power control strip. To reset the RSA, plug the remote power control strip of the
failing RSA card into another power source and issue the power off and power on
commands to the RSA port.

Checking service processor logs

At the console prompt, type, lsnode -Al to determine the host name for the Remote
Supervisor Adapter (RSA) card and the service processor name associated with the
node. At the console prompt, telnet, use SSH, or open a Web browser to connect to
the RSA card using the host name, and select View Log.

Management, cluster, and storage node problems

The IBM components used for management, cluster, and storage nodes are shown
in Table 21:
50 IBM Eserver Cluster 1350 Installation and Service Guide
Table 21. IBM components used for management, cluster, and storage nodes
Node type
Management node
Cluster node
Storage node
IBM component used
v xSeries 345
v Eserver 325 (64-bit operating system
environment)
v Eserver 325
v xSeries 335
v xSeries 345
v BladeCenter
v Eserver 325
v xSeries 335 (do not use in a
Fibre-Channel storage configuration)
v xSeries 345
v xSeries 360