Extreme Networks 8820 Hardware Installation Manual page 38

Attach the Device to a Two-Post Rack
Figure 19: Attaching a Long Mounting Bracket: Middle of Device Router
b. Use six small mounting screws (provided) to attach the bracket to the device.
c. Secure the long bracket to the rack post. (Rack-mounting screws are not provided.)
4. Repeat step
5. Tilting the device slightly, lift it into the rack so that the mounting brackets align with the rack posts.
If the device cannot be tilted (because other equipment is mounted directly above and below),
remove one or both short mounting brackets from the device. Lift the device into position, secure
the flanges (ears) on the long brackets to the rack posts, and then reattach the short brackets.
6. Secure the flanges (ears) on both sides of the device to the rack posts, using screws that are
appropriate for the rack. (Rack-mounting screws are not provided.)
See Figure 20
38 Extreme 8820 Hardware Installation Guide
3 to attach the other long bracket on the other side of the device.
for the completed installation.
Install Your Switch