Table of Contents
Advertisement
12
You can adjust them manually by hand or
by using a suitable tool.
To allow the doors to self-close, tilt the
top backwards by 10~15mm.
Caution!
Let your refrigerator stand upright for
approximately 4 hours before connecting it
to power. This reduces the possibility of a
malfunction in the cooling system from
improper handling during transportation.
Wait for approximately 2 hours after
moving your appliance or plugging it in for
the first time so that the coolant fluid
settles.
If you do not level your refrigerator during
installation, the doors may not close or
seal correctly which can cause cooling,
frost, or moisture problems.
2. Door removal
In case your home access door is too
narrow for the refrigerator to pass through,
remove the refrigerator doors and drawers
by the following instructions.
Tools you will need (Not provided):
Allen Wrench (4mm)
Philips Screwdriver
2.1 Disassembling the fridge door
Some models may be slightly different
from pictures. If some parts shown in the
picture cannot be found in your appliance,
please ignore the relevant description.
1. With the door closed, remove the 3
screws holding the top cover (A) with
Philips (+) screwdriver, and then remove
the top cover with the entire-harness
attached.
2. Remove the 3 screws (B) fixed on the
hinges with a wrench (8mm) and 1 ground
screws (C) attached to the hinge with
Philips (+) screwdriver. Remove the upper
left and right door hinges (D).
3.Use your both hands to open the door
more than 90° .Lift it up and take it off.
Wrench (8mm)
Advertisement
Table of Contents
