Table of Contents
Advertisement
14
Re-assembling the freezer door
To reattach the drawer after you moved
the
appliance
to
assemble the parts in reverse order.
Warning!
Switch off the appliance and disconnect
it from the main power before removin
g or re-assembling the door.
3. Installing the water lines
A water dispenser with a filter is one of the
helpful features on your new appliance. To
help promote better health, the water filter
removes unwanted particles from your
water. However, it does not sterilize or
destroy microorganisms. You may need to
purchase a water purifying system to do
that.
In order for the ice maker to operate
properly, a water line is required.
-the maximum inlet water pressure is
896kPa;
-the minimum inlet water pressure is
207kPa.
Warning:
The water connection must be made by a
qualified plumber. Operation outside the
water
pressure
range
malfunction, severe and damaging water
leaks.
Under normal conditions, a200cc (5.75 oz.)
cup can be filled in about 10 seconds.
If the refrigerator is installed in an area
with low water pressure (below 30 psi),
you can install a booster pump to
its
final
location,
may
cause
compensate for the low pressure.
3.1 Connecting the water supply
You will need the following tools and parts
(not included):
You need to purchase several items to
complete this connection. You may find
these items sold as a kit at your local
hardware store.
CAUTIONS:
Make sure that you:
Use the tubing that came with your
refrigerator
and
installation kit. Do not use old tubing.
Connect to the cold-water pipe. If you
connect to the hot water pipe, the purifier
may malfunction.
Connect with the potable water only.
Do not contaminate the water pipes
during installation.
1. Shut off the main water supply.
2. Using a 1/4" drill bit, drill a hole into the
cold water line, then install the saddle-type
shutoff valve.
the
water
supply
Advertisement
Table of Contents
