Lever Switch; Basic Parameters; Checking Method - Hisense BCD-740WPCZR/HC1(H) Service Manual

48
Step 3: Remove the two screws (3) with a Philips screwdriver.
Step 4: Remove the dispenser and remove the two wire connector (4) by pressing the top
of them.

6.11 Lever switch

6.11.1 Basic parameters

Rated voltage: DC 5V

6.11.2 Checking method

1. Check the connecting wiring of the switch is well or not, repair if it is broken. The switch
corresponding pin No.17 and No.25 on CN8 connector of the main-board as the drawing
below.
2. Under normal condition, the two pins of switch is open circuit; Under press condition,
the two pins of switch is short circuit. If the result is abnormal, change the switch.
Hisense Refrigerator