Table of Contents
Advertisement
54
6.13 Ice maker
6.13.1 Checking method
When the ice maker can not work, please check according to the following steps
Step 1.Check water line connection
Step 2.Check the connecting wiring between icemaker and mainboard is well or not.
Repair if it is broken.
Step 3. Touch and hold"Alarm"button+"Ice Off" button for 3 seconds in 10 minutes after
power-on, the ice maker will be operated, if not, please change ice maker part.
6.13.2 Remove the ice maker part
Before removing all parts in the ice-making room, you must do forced defrosting for your
appliance. After thoroughly defrosting, unplug the appliance.
Step 1: Remove the three screws holding the top cover with a Philips screwdriver.
Step 2: Remove the two screws holding the upper hinge and the earthing screw with a
Philips screwdriver.
Step 3: Rotate door hinge as picture, loosen the last screw holding the door hinge if
necessary.
Step 4: Remove the ice bucket (A) with your hand in the direction of the arrow.
Step 5: Remove the screw holding the wire harness cover (B) with a Philips screwdriver.
Step 6: Remove the wire harness cover(B) by sliding out.
Step 7: Remove the second wire connector by pressing the top of it as picture shown.
Step 8: Pry the Ice making chamber (C) out the cabinet liner with a Philips screwdriver,
especially the corner as shown in the picture.
Step 9: Remove the Ice making chamber (C) with your both bands in the direction of the
arrow.
Step 10: Remove the screw holding the ice maker fan cover (D) with a Philips screwdriver.
Step 11: Remove the ice make fan cover (D) by pressing the buckle and remove the wire
connector by pressing the top of them.
Step 12: Remove the screw holding the fix block (E).
Step 13: Pry the evaporation tube (F) out the ice maker with a Philips screwdriver.
Step 14: Remove the first wire connector by pressing the top of it as picture shown.
Step 15: Remove the ice maker (G) by pressing the buckle as picture shown.
Hisense Refrigerator
Advertisement
Table of Contents
