Charging Time - Parkside PWSA 20-Li D4 Translation Of The Original Instructions

GB
Bore hole ............................ 22.23 mm
Thickness ........................... max. 6 mm
Spindle thread .................................M14
Thread length .............................. 11 mm
Sound pressure level
(L )....................... 83.1 dB; K
pA
Sound power level (L
measured.............. 94.1 dB; K
Vibration level (a )
h
Device handle .. 3.38 m/s
Handle ........... 3.73 m/s
For use with smart batteries
(Smart PAPS 204 A1/Smart PAPS 208 A1)
Operating frequency/
Frequency band .... 2400 - 2483.5 MHz
Max. transmission power .......≤ 20 dBm
Vibrations levels are the maximum values
generated by the cutting discs supplied.
The actual vibration values may vary de-
pending on the used accessories.
The vibration values are still affected by
the handling for the user's.
Cutting disc .......... PTS 125 A24QBF
Idling speed n ..................12200 min
max
Disc speed v ............................ 80 m/s*
0
Outer diameter ................... Ø 125 mm
Bore hole ........................ Ø 22.23 mm
Thickness ................................... 1 mm
*
The cutting disc must withstand a rotational
speed of 80 m/s.
Levels of noise and vibration were determi-
ned according to the norms and regulati-
ons in the declaration of conformity.
The vibration emission value has been
measured according to a standardised
testing method and may be used for com-
parison with another electric tool.
28
= 3 dB
pA
)
WA
= 3 dB
WA
2 ; K= 1.5 m/s
2 ; K= 1.5 m/s
(included)
The indicated vibration emission value
may also be used for an introductory
assessment of the exposure.
Warning: The vibration emission
value whilst actually using the elec-
trical tool may vary from the given values
independently of the type and way in
which the electric tool is used.
Try to keep the exposure to vibrations as
2
2 low as possible. Examples of measures to
reduce vibration exposure are the wearing
of gloves when using the tool and limiting
the working hours. For this purpose all parts
of the operating cycle have to be conside-
red (for example, times when the electric
tool is switched off and times when it is
switched on but running without any load).

Charging time

The device is part of the (Parkside) X 20 V
TEAM series and can be operated with bat-
teries of the (Parkside) X 20 V TEAM series.
Batteries of the (Parkside) X 20 V TEAM
series may only be charged using chargers
of the (Parkside) X 20 V TEAM series.
-1
We recommend that you operate this appli-
ance with the following batteries only:
PAP 20 B1, PAP 20 B3,
Smart PAPS 204 A1, Smart PAPS 208 A1
We recommend charging these batteries
with the following chargers:
PLG 20 A3, PLG 20 A4, PLG 20 C1,
PLG 20 C2 PLG 20 C3, PDSLG 20 A1,
Smart PLGS 2012 A1
An up-to-date list of battery compatibility
can be found at: www.lidl.de/akku