Connecting To Control Connectors; Connecting The J1 Connector - Kikusui PAT-TM Series Setup Manual

4

Connecting to Control Connectors

This chapter explains how to connect to the J1 connector to perform external control and
how to connect to a factory optional interface board to perform remote control.

Connecting the J1 Connector

You can control the PAT-TM/TMX series externally through the J1 connector on the rear panel
of the master unit.
For details on external control and how to perform it, see the PAT series operation manual.
Possible electric shock.
WARNING
• Turn the power off before you remove the rear panel. On the PAT-TMX series, turn the
breaker switch off. On the PAT-TM series, turn each power supply's POWER switch off.
• Never remove the rear panel and wire the J1 connector if the PAT-TM/TMX series is on (the
breaker switch is in the on position or any of the POWER switches are in the on position).
1
2
3
PAT-TM/TMX
On the PAT-TMX series, turn the breaker switch off. On the PAT-TM series, turn
each power supply's POWER switch off, slave units first and then the master
unit.
Remove the topmost rear panel.
You can now see the master unit rear panel.
Remove the protective socket that is attached to the J1 connector.
J1 connector
Wiring opening
(the opening on the left
edge of the rear panel)
J2 connector
Screw (M4x8)
29