Connecting The Interface Connector (Factory Option) - Kikusui PAT-TM Series Setup Manual

Connecting the Interface Connector (Factory Option)

In addition to controlling the panel from the front panel, you can control it remotely through the
factory optional interface. To do so, the interface connector on the rear panel of the master
unit is used. For details on remote control and how to perform it, see the PAT series operation
manual.
Possible electric shock.
WARNING
• Turn the power off before you remove the rear panel. On the PAT-TMX series, turn the
breaker switch off. On the PAT-TM series, turn each power supply's POWER switch off.
• Never remove the rear panel and connect the interface connector if the PAT-TM/TMX series is
on (the breaker switch is in the on position or any of the POWER switches are in the on
position).
1
2
3
4
PAT-TM/TMX
On the PAT-TMX series, turn the breaker switch off. On the PAT-TM series, turn
each power supply's POWER switch off, slave units first and then the master
unit.
Remove the topmost rear panel.
You can now see the master unit rear panel.
Connect the cable to the factory optional interface connector.
Interface connector
(Example of GPIB）
Wiring opening
(the opening on the left
edge of the rear panel)
RS232C connector
Attach the rear panel that you removed in step 2 . When you attach the
rear panel, pass the cable that you connected to the interface connector
through the open space on the left edge of the panel.
Screw (M4x8)
LAN USB
31