IDEAL FP14KC-X Installation & Operation Manual page 12

7) Route specific cable ends 'down & around' each crossbeam cable pulley and up, making sure cables
are not crossed inside crossbeams, Fig. 8.
8) Bolt the front of runways with wheel stops onto the front crossbeam by aligning the two holes in the top
of the front crossbeam tube with the slots in the runway end plates and the holes in the front wheel stops.
Secure runway & wheel stop to the crossbeam using four M12 x 40mm hex flange bolts, Fig 9.
Wheel Stop
Front
Crossbeam
9) Bolt the rear of runways onto the rear crossbeam by aligning the holes in the top of rear crossbeams
tube, secure using four M12 x 30mm hex flange bolts.
NOTE: The Offside Side Runway can be mounted to the Crossbeams in two positions for either
narrow or standard width configurations. Standard width is highly recommended.
Lift Cable
Cable
Pulley
Fig. 8
M12 x 40mm
Hex Flange Bolts
Fig. 9
12
FP14KC-X
JAN 2023