Remote Control - NEC MultiSync LCD2335WXM User Manual

Component Names and Functions

Remote Control

PROGRAM / ADJUST ( )
Installing the Batteries
1. Open the battery cover.
Slide back and remove the battery cover in
the direction of the arrow.
2. Installing the batteries.
Install two included Size AAA batteries
observing the correct polarities(+,-).
3. Close the battery cover.
Replace the battery cover in the direction
of the arrow and snap it back into place.
CAUTION
Do not mix new and old batteries together. The batteries could explode or
leak, resulting in fires, physical injury, or stains.
When inserting batteries, observe their correct polarities as marked on the
product. If inserted in the wrong direction, the batteries could explode or leak,
resulting in fires, physical injury, or stains.
TV TUNER
NUMBER KEYPAD
CH-LOCK
SLEEP
MENU
ENTER
PIP
DISPLAY
ASPECT
AV1
RGB-1VGA
AV2
RGB-2 DVI
Use the remote control within about 16 feet from front of the unit's remote-
control sensor and within 30 degrees on both sides.
5
continued
LED INDICATION
POWER ON/OFF
VOLUME UP / DN ( )
CH UP / DN ( )
ZOOM
LAST-CH
SOURCE SELECT
SELECT ( )
PROGRAM / ADJUST ( )
SWAP
MTS
CCD (Close Caption Display)
MUTE
STILL
AV3
AV4
Handling the Remote Control
Within 30 degrees
About 10 feet
About 16 feet
ATTENTION
Do not drop the remote control.
To avoid possible failures, do not splash the remote control with water
or put it on a wet object.
If leaving the remote control out of use for an extended period of time,
remove the batteries from it.
If the remote control does not respond properly, replace the batteries.
Strong light such as direct sunlight exposed on the photoreceptor of
the remote control can cause operational failure. Position this unit to
avoid direct contact with such light.
Within 30 degrees
About 10 feet